XRC-2... THE REAR SUPPORT ARM BRACKET FAILURE!
HOW TO MANUFACTURE A METAL ONE - ONE PIECE
---------------------------------------------------------------------------------------------------------------------------

OK THIS IS SIMPLER BUT CAN BE A BIT RICKETY...
BUT IF YOU JUST FOLLOW THE INSTRUCTIONS ITS A REALLY EASY BUILD..

DIAG-02 - YOU MICGHT FIND THAT WHEN YOU GET THE BRACKET ON THAT YOU NEED TO CUT
OFF THE CORNERS SO IT CAN SWING PROPERLY WHEN ITS ATTACHED.

OK NOW TO MY CRAPPY DRAWING - SIMPLY PUT A NUT ON THE SHAFT, FEED IT THROUGH THE HOLE
AND PUT ANOTHER NUT ON THE OTHER END... TRACK IT IN AND ITS DONE.